This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
howto:mavic_gps_disconnected_compass_wont_calibrate_fix [2018/08/12 10:09] aciid added creds for helping |
howto:mavic_gps_disconnected_compass_wont_calibrate_fix [2018/08/12 19:37] (current) aciid added pictures |
||
---|---|---|---|
Line 8: | Line 8: | ||
With your GPS board now facing you take a picture of the wire's color/pin ordering. | With your GPS board now facing you take a picture of the wire's color/pin ordering. | ||
+ | |||
+ | {{: | ||
Scrape off the white goo with nylon chisel tips and remove any remaining goo with a soldering iron at 300'C. | Scrape off the white goo with nylon chisel tips and remove any remaining goo with a soldering iron at 300'C. | ||
Line 14: | Line 16: | ||
You should end up with something like this. | You should end up with something like this. | ||
+ | |||
+ | {{: | ||
Rework the wires with your fingernails or a craftpen, they are really too thin to strip with tools. Apply a thin coat of solder to the tips to make it easier to attach them back to the pads. Then just solder wires back to pads. | Rework the wires with your fingernails or a craftpen, they are really too thin to strip with tools. Apply a thin coat of solder to the tips to make it easier to attach them back to the pads. Then just solder wires back to pads. |