This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
howto:mavic_gps_disconnected_compass_wont_calibrate_fix [2018/08/12 08:47] aciid created |
howto:mavic_gps_disconnected_compass_wont_calibrate_fix [2018/08/12 19:37] (current) aciid added pictures |
||
---|---|---|---|
Line 8: | Line 8: | ||
With your GPS board now facing you take a picture of the wire's color/pin ordering. | With your GPS board now facing you take a picture of the wire's color/pin ordering. | ||
+ | |||
+ | {{: | ||
Scrape off the white goo with nylon chisel tips and remove any remaining goo with a soldering iron at 300'C. | Scrape off the white goo with nylon chisel tips and remove any remaining goo with a soldering iron at 300'C. | ||
Line 14: | Line 16: | ||
You should end up with something like this. | You should end up with something like this. | ||
+ | |||
+ | {{: | ||
Rework the wires with your fingernails or a craftpen, they are really too thin to strip with tools. Apply a thin coat of solder to the tips to make it easier to attach them back to the pads. Then just solder wires back to pads. | Rework the wires with your fingernails or a craftpen, they are really too thin to strip with tools. Apply a thin coat of solder to the tips to make it easier to attach them back to the pads. Then just solder wires back to pads. | ||
Line 20: | Line 24: | ||
If everything works well you should now have a working GPS connection, but probably end up with a " | If everything works well you should now have a working GPS connection, but probably end up with a " | ||
+ | |||
+ | Thanks to: Andris8888, Lolo780 |