This is an old revision of the document!
Manual Steps to try if SuperPatcher or FCChooser doesnt work
1. Make a new folder and name it something simple like SP
2. Download these files:
Download dumldore and unzip into folder
Download adb files:
Download firmware file
Download dummy_verify.sh
3. Copy all into same folder
4. Connect aircraft to the computer and power it on.
5. Open DumlDore. Click “Enable ADB” in DUMLdore and then close DUMLdore
6. From a command prompt, open the same folder as your files (Adb.exe, the firmware file, etc)
7. Run these commands from cmd prompt
8. Now, different commands depending on aircraft.
## If Mavic/Spark, use these commands
## If P4 series, I2 run these commands
9. Power off the aircraft. Keep it plugged into the PC. Power it back on.
10. Open DumlDore. Click “Enable ADB” in DUMLdore and then close DUMLdore
11. From a command prompt, open the same folder as your files (Adb.exe, the firmware file, etc).
12. Open a cmd prompt
13. Now, different commands depending on aircraft.
## If Mavic/Spark, use this command:
## If P4 series, I2 run this command:
14 .Keep the aircraft powered on and plugged in!
15. Now, you can flash your aircraft. Open dumldore. Press load firmware, navigate to the firmware file you downloaded earlier. Press flash firmware. Let it do its magic.
Don't power off aircraft during firmware flash.